Evolution Aqua EazyPod Automatic Pond Filter 18w Uv steriliser

The Evolution Aqua EazyPod Automatic.

Is a compact, self-cleaning pond filtration system designed to provide effective mechanical and biological filtration for koi and garden ponds up to 10,000 litres.

Its automatic cleaning system reduces routine maintenance, using a programmable timer to clean the filter media and discharge collected waste, even when you're away.

It's Recommend not for gravity setup but it is very possible to install this setup as gravity fed with little alterations needed, there are a some components needed in order for the EasyPod to clean properly but the same components should be fitted anyway into pump fed setup too.

See Instruction Below.

Key Features

• Automatic self-cleaning with adjustable timer

• Mechanical and biological pond filtration

• Suitable for ponds up to 10,000 litres

• Supplied with 18 litres of K1 Micro filter media

• Integrated air pump for automatic cleaning

• Automatic motorised waste valve

• Maximum flow rate of 10,000 litres per hour

• Compact design for koi and garden ponds

• 18w Uv Steriliser

Important: This is the standard EazyPod Automatic without built-in UV. A separate UV clarifier and pond circulation pump are required and are not included.

Supplied by LifeTime Ponds Ltd, with practical experience installing and maintaining Evolution Aqua filtration systems.

Gravity Fed setup Instructions.

Installing 1x 1 1/2" Non Return valve onto the return line to pond - (Make sure the arrow is pointing the right direction upwards)

1x 4" slide Gate Valve or 4" ball value to the bottom drain 4" pipe - (4" Non Return will work better but costly)

1x Rubber Boot Connecter from 4" to 2 1/2"

Cut back the EasyPod water inlet to next step like a horsetail - (Make sure its the right step the boot connects too)

Cut down the inside upright overflow pipe inside the EasyPond around 2" lower - (Pence Grinder)

Set EasyPod to the correct hight making sure its not too high or too low - (Pond Max water hight set to the 3 EasyPond overflow between the two chambers water & K1, this will be the EasyPod Max Level now)

Please note - doing this set up will mean installing an auto top up is critical unless you turn the auto clean off doing the clean manually which is a better option.

Also the auto valve timer will need to be adjusted in order for the auto value to open loner when draining cycle is in progress giving the correct amount of time for all water to escape the EasyPod.

Inside the EasyPod there are 3 sets of timer controls, 2 looking the same on the LHS, one having a complete sticker over it saying (DO NOT REMOVE) this is the timer you need to change.

Highly Recommend - Remove the sticker take a picture before changing anything, this can make serious issues you can't repair once forgotten. change the one timer up 1 increment making sure the EasyPod is full with water, have a stopwatch starting the same time as you press clean. Pay attaching to what lever the water goes too before the valve closes again and this will indicate more and repeat again till you happy with the time of open time before closing again.

Make sure all water has left the EasyPond before auto valve closes allowing all muck to have a chance to escape before the next cycle begins.